4/13/2023 0 Comments Deskcnc keygen serials![]() ![]() The software should then detect the controller, provided you set the correct serial port, etc. You do not need to connect any stepper motors, or ancillaries, but you must connect the Estop terminal to gnd. To test the controller and software, it is only necessary to connect the serial cable and power supply. The pcb silk screened annotation should be correct. Please check the position of the connections against your pcb. The actual component and connection layout of your pcb may differ from that shown here, certainly the firmware version has been superceded. The controller card, like the software, is under continuous development, and new features and other changes often occur. RWC - DeskCNC controller board DeskCNC Controller Board - Connections
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |